LG SIGNATURE WM9500HKA Owner's Manual download pdf (Page 12)

12 INSTALLATION

Unpacking and Removing

Shipping Bolts

Lift the washer off the foam base.

After removing the carton and shipping material,

lift the washer off the foam base. Make sure the

plastic tub support comes off with the base and

is not stuck to the bottom of the washer.

If you must lay the washer down to remove the

base packaging materials, always protect the

side of the washer and lay it carefully on its side.

Do not lay the washer on its front or back.

Foam tub

support

Carton base

Remove the bolt assemblies.

Starting with the bottom two shipping bolts, use

the wrench (included) to fully loosen all four

shipping bolts by turning them counterclockwise.

Remove the bolt assemblies by wiggling them

slightly while pulling them out.

Retainer

Shipping

bolt

Install the hole caps.

Locate the four hole caps included in the

accessory pack and install them in the shipping

bolt holes.

Cap

NOTE

• Save the bolt assemblies for future use. To prevent

damage to internal components, do not transport

the washer without reinstalling the shipping bolts.

• Failure to remove shipping bolts and retainers may

cause severe vibration and noise, which can lead

to permanent damage to the washer. The cord is

secured to the back of the washer with a shipping

bolt to help prevent operation with shipping bolts in

place.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 52 53

No comments

LG SIGNATURE WM9500HKA Owner's Manual Page 12